Perkins — Page 1

Chapter 6 N38143 Standard control system (optional on 4.4 range) A standard control system is available when used with a factory supplied engine wiring harness, that allows for the control of the genset including start and stop functions, which can be performed remotely with the appropriate panel. The control module is able to display any fault condition that may occur with automatic shutdowns being available where programmed. The main control also includes three analogue gauges, indicating the operational status of the engine. The automatic engine control module contains the following features: The following relay outputs are provided:

Fuel solenoid output Start output Pre-heat Common shutdown Not in auto The following inputs are provided: Governor failure alarm Lamp test Two spare inputs Multiple alarm channels are provided to monitor the following: Under/overspeed DC alternator charge fail Emergency stop Low oil pressure High coolant temperature Fail to start Loss of speed sensing The standard control can be mounted remotely if required. This is achieved by using a 4.57m (15ft) extension lead which is inserted between the connectors at the rear of the control box. This places the extension lead in series with the two connectors, one from the engine and the other in the rear of the control box. Page 58