Perkins — Page 1

Data N38143 Pipe size: • Supply - Outside diameter......................................... 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................ 4.93mm (0.194”) Maximum lift pump lift (clean filter).......... 0.8m (2.6ft) To bottom of tank suction pipe Maximum fuel lift pump depression at inlet...................

127mm (5”)Hg Fuel consumption at full power.......3.7 l/hr (1.0 US galls/hr) ..........4.5 l/hr (1.2 US galls/hr) Air Intake Combustion airflow................................................ 1.07m 3 /min (37.9 ft 3 /min) 1.26m 3 /min (44.4 ft 3 /min) Maximum engine compartment air temperature.............60 o C (140 o F) Maximum air temperature at engine inlet........................52 o C (126 o F) Ventilation - maximum engine room depression..................................................... 125mm H 2 O (5in H 2 O) Minimum cross section of air duct (per engine)...................................65 cm 2 (10 sq ins) for hot climates.

................................................................ 32 cm2 (5 sq ins) for temperate climates. Exhaust Exhaust gas flow............................. 2.75m 3 /min (97ft 3 /min)............ 3.37m 3 /min (119ft 3 /min) Maximum restriction measured within (305 mm) 12” outlet..........................................10.13kPa (3.0” Hg) Recommended pipe bore (wet exhaust).........................50mm (2.0”) Recommended pipe bore (dry).......................................40mm (1.6”) Minimum rise from sea water level to exhaust outlet centreline............................................203mm (8.0”) Lubricating System Recommended lubricating oil....................................

AP1 CH4 ACEA E5 Sump capacity maximum......................................6 litres (1.5 US galls/min) Normal operating angles............................... 25 o from horizontal in any direction Oil pressure, in operating speed range (steady state)...........................................200kPa (29psi) Low oil pressure switch setting......................................80kPa (12psi) Electrical System Generator..........................................................................55A (12V) Starter...........................................................................

12 volt 2.0 kW Number of teeth in flywheel....................................................109 Number of teeth on starter.......................................................9 Cold Start Limits Minimum cold start temperature (with aid)....................... -15 o C(5 o F) Batteries for min cold start........................... 1 x 12 volt 540 amp SAE to BS3911 or 1 x 12 volt 740 amps to SAE J537 Page 66