Perkins — Page 1

Data N38143 Pipe size: • Supply - Outside diameter......................................... 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................

4.93mm (0.194”) Maximum lift pump lift (clean filter)...........0.8m (2.6ft) to bottom of tank suction pipe Maximum fuel lift pump depression at inlet...................127mm (5”) Hg Fuel consumption at full power.......5.2 l/hr (1.4 US galls/hr) ..........6.2 l/hr (1.6 US galls/hr) Air Intake Combustion airflow.........................1.46m 3 /min (51.5ft 3 /min)...........1.76m 3 /min (62ft 3 /min) Maximum engine compartment air temperature.............60 o C (140 o F) Maximum air temperature at engine inlet........................52 o C (126 o F) Ventilation - maximum engine room depression.....................................................

125mm H 2 O (5in H 2 O) Minimum cross section of air duct (per engine).................................. 103cm2(16sq ins) for hot climates. ................................................................52cm 2 (8sq ins) for temperate climates. Exhaust Exhaust gas flow............................

3.51m 3 /min (124ft 3 /min)...........4.45m 3 /min (157ft 3 /min) Maximum restriction measured within (305 mm) 12” outlet.........................................10.13 kPa (3.0” Hg) Recommended pipe bore (wet exhaust).........................50mm (2.0”) Recommended pipe bore (dry).......................................40mm (1.6”) Minimum rise from sea water level to exhaust outlet centreline............................................203mm (8.0”) Lubricating System Recommended lubricating oil.................................... AP1 CH4 ACEA E5 Sump capacity maximum...................................

10.6 litres (2.7 US galls/min) Normal operating angles....................................25 o continuously at all angles Oil pressure, in operating speed range (steady state)...........................................200kPa (29psi) Low oil pressure switch setting......................................80kPa (12psi) Electrical System Generator..........................................................................55A (12V) Starter...........................................................................

12 volt 2.0 kW Number of teeth in flywheel....................................................126 Number of teeth on starter.......................................................9 Cold Start Limits Minimum cold start temperature (with aid)....................... -15 o C(5 o F) Batteries for min cold start.............................. 1 x 12 volt 540 amps to BS3911 ..................................................................or 1 x 12 volt 740 amps to SAE J537 Page 68