Perkins — Page 1

Data N38143 Pipe size: • Supply - Outside diameter......................................... 7.9mm (0.315”) • Supply - Bore............................................................ 6.53mm (0.257”) • Return - Outside diameter.......................................... 6.3mm (0.25”) • Return - Bore............................................................ 4.93mm (0.194”) Maximum lift pump lift (clean filter)........... 17kPa at 1.7m using 8mm dia. bore pipe Maximum fuel lift pump depression at inlet...................127mm (5”) Hg Fuel consumption at full power......12.2 l/hr (3.2 US galls/hr) ........14.5 l/hr (3.8 US galls/hr) Air Intake Combustion airflow........................

3.19m3/min (113 ft3/min).........3.58m3/min (126 ft3/min) Maximum engine compartment air temperature............60 O C (140 O F) Maximum air temperature at engine inlet.......................52 O C (126 O F) Ventilation - maximum engine room depression.....................................................125mm H 2 O (5 in H 2 O) Minimum cross section of air duct (per engine)..................................232 cm 2 (36 sq ins) for hot climates. .............................................................116 cm 2 (18 sq ins) for temperate climates.

Exhaust Exhaust gas flow.............................7.6m 3 /min (268 ft 3 /min)............8.8m 3 /min (311 ft 3 /min) Maximum restriction measured within (305 mm) 12” outlet............................................15kPa (4.4” Hg) Recommended pipe bore (wet exhaust).........................76mm (3.0”) Recommended pipe bore (dry)......................................57mm (2.25”) Minimum rise from sea water level to exhaust outlet centreline............................................203mm (8.0”) Lubricating System Recommended lubricating oil............................. AP1 CG4/CH4 ACEA E3/E5 Sump capacity maximum....................................

8.5 litres (2.2 US galls/min) Normal operating angles...............................25 O from horizontal in any direction Oil pressure, in operating speed range (steady state).......................................... 250kPa (36 psi) Low oil pressure switch setting..................................... 83kPa (12 psi) Electrical System Generator................................................................100A (12V), 55A (24V) Starter...........................................................................

12 volt 4.0 kW Number of teeth in flywheel....................................................126 Number of teeth on starter.......................................................9 Cold Start Limits Minimum cold start temperature (with aid).......................-15 O C(5 O F) Batteries for min cold start....................................1 x 12 volt 660 Amp SAE Page 78