Komatsu — CONTROL LEVERS AND PEDALS

. OPERATION EXPLANATION OF COMPONENTS PARKING BRAKE LEVER WARNING position. This lever (5) is used to apply the parking brake. WORK EQUIPMENT LOCK LEVER WARNING When standing up from the operator's seat, always move the work equipment lock lever securely to the LOCK position. If the blade control and ripper control levers are not locked and are 3 - 58 When parking the machin e, always set the parking bra ke lever to the L OCK REMARK Before moving the parking brake lever to the LOCK position, return the steering position.

, directional, and gearshift lever to the N When starting the e ngine, if the parking brake lever is not in the LOCK position, the limit switch is actuated a nd it is i mpossible to start the engine. touched by accident, i If the work equipment t may lead to serious injury lock lever is not completely i or damag n the LOC e. K position, the lock may not be a pplied. position shown in the diagram. chine or when performing maintenance, always Check that it is in the position shown in the diagra When parking the ma chine or when performing m ways lower the blade or rip per to the ground, then set the work equipment lock lever to the LOCK position.

Lever (6) is a device t o lock the blade control an d ripper cont rol levers. When it is set to the L OCK position, the TILT, R AISE, L OWE R, an d FLOAT operations a REMARK ine, to ensure safety, always place the work equipment lock lever at the LOCK position. When starting the eng ine, to ensure safety, alw ays plac e the work equipment lock lever at the LOCK position If the work equipment l ock lever is not at the LOC K position, th e limit switch is actuated an d the engine will not s tart.