. OPERATION EXPLANATION OF COMPONENTS OPERATION EXPLANATION OF COMPONENTS (E) FORWARD PITCH: Cutting angle is increased. 3 - 60 (D) REAR PITCH : Cutting angle is REMAR The blade ca n be pitched when lever (7) is in the raise, To p itch the b lade, operate leve r (7) to the left (D) or rig ht (E) while depressing pitch button (C Whe n the blade is about the ne utral cutting angle (pitch angle), the cylinder rod starts appear ing from the right cylinder cover bottom (F positio n). If the cylinder rod is seen clear (G position), the blade is pi tched in for ward. If the former i s not seen at all ( H position), the latter is p itched in rear.
itch angle) between the At p ushing up operation, set th e blade cutting angle (p forward pitch angle. This settin g can prevent the dirt fro m spilling from the bowl on the front sid e of the bla de or over the blad e top. Whe n leveling the ground in rev erse with the lever in the float position, set the bl ade at the neu tral blade c utting angl e (pitch a ngle) to finish the (F) (G) (H) Position at which cylinder rod starts appearing Position at which cylind seen clear er rod is Position at which cylinder r not seen at all Neutral pitch angle Forward pitch Rear pitch