Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION REMARK checking. 3 - 94 If the machine is at an angle, reposition it to level before checking. When checking the oil level af ter the engine has been operated, allow the engine to coo l for 15 minutes b efore CHECK DUST INDICATOR e left side of machine. 1. 2. 3. 4. 1. Open engine side cover on th Check if the yellow piston in t red zone on the outside. he dust indicator (1) overlaps the If the yellow piston overlaps t filter element immediately. For the filter element clea CLEAN AND REPLACE AIR he red zone, clean or replace the ning procedure, see "CHECK, CLEANER ELEMENT (PAGE 4-20)"".

After checking, cleaning, and replacing, press the knob of dust indicator (1) to return the yell ow piston to its original position. CHECK, DRAIN WATER SEPARA TOR The water separator serves to se parate moisture mixed in the fuel. 1. Open up the engine side cov The water separator is in one located in the lower part. 2. The water level and sedime cap (2). When water and disconnect drain hose (3) fro the machine and put in a co sediment. 3. Loosen plug (5) to drain the 4. After draining through dra immediately and pass drain h Tightening torque: 0.2 to 0 0.3 lbft) 1. Open up the engine side cov er on the left side of the machine. The water separator is in one located in the lower part.

piece with fuel pre-filter (1) and nt are seen through transparent sediment have accumulated, The water level and sedime cap (2). When water and disconnect drain hose (3) fro the machine and put in a co sediment. m clip (4) and take its end out of ntainer to receive the water and water. in hose (3), tighten plug (5) ose (3) through clip (4). 3. Loosen plug (5) to drain the 4. After draining through dra immediately and pass drain h Tightening torque: 0.2 to 0 .45 Nm (0.02 to 0.046 kgm, 0.1 to