. OPERATION OPERATION STOPPING ENGINE allow it to cool down gradually, then stop it. The engine will stop 4. Remove the key from starting switch (2). 3 - 119 NOTICE If the engine is stopped w ithout allowing it to cool down , there is dange that the service life of vari in emergencies, never sto If the engine overheats, d ous parts of the engine will be reduced. Excep p the engine suddenly. o not stop it suddenly. Run it at low speed t 1. Lower the work equ ipment to the ground. 2. Place fuel control di al (1) in the low idle (MIN) p osition and ru the engine at low id gradually cool dow le speed for about 5 minutes to allow it t n. es to a 3.
Turn the key in igni tion switch (2) to the OFF p osition REMARK When engine startin g switch (2) key is turned to the OFF position, the engine stops, but the machine's main turned off immediately. ovided for the controller to memorize the operation status and then terminate the system. power source is not This is a time lag pr While this process c operation condition. ovided for the controller ontinues, the main power is maintained. The power holding time varies depending on the ng fan is used for a cleaning purpose, the machine's main power source is not turned off engine starting switch (2) key is turned to the OFF position.
Also when the cooli immediately, even if This time lag is provi for seven seconds. engine starting switch (2) k ey is t urned to ded to protect the hydraulic circuit, and in t his case, the machine's m ain power is maintained