. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT ADJUST ANGLE OF BLADE EDGE WARNING in a ANGLE DOZER CAUTION 3 - 140 It is d angerous if t he work equipment m oves by mistake w hen a djusting angle of the blade edge. Set the wo stabl e condition, t hen stop the engine a nd lock the work e quipm ent securely with the work equipment lock le Blad e cutting ed ge angle (A) can be adjusted t o me et soil conditions. STRAIGHT TILT DOZER r with screw-adjustable tilt brace.
with bar handle (1) to extend a distance between Straight tilt doze r with screw-adjust able tilt bra Turn the brace with bar handle (1) to extend a etween the j oints (B), an d then blade cutting edge angl e (A) i ncreases. To decrease the an gle, shorten the dis tance. A) is 55°. ts (B) is as shown below. Standard blade cutting edge angle ( Standard distan ce between the join ts (B) is as show n belo D65EX: 1150 m m (45.31 in) m (45.15 in) D65PX: 1146 m REMARK Whe n the mach ine is installed with a fixed type tilt b race, a blade cutting ed ge angle cannot be ad Standard blade cutting edge angle ( A) is 55°.
Whe n the blade cutting edge is held at the standard angl e, the tilt amount is D65EX: 460 mm D65PX: 450 mm The a ngle of the b lade edge of the angle dozer blade can n ot be a djusted. If the angle of the blade edge is changed by changin g the b race le ngth, an excessive b ending stress will be ap pin, w hich may be broken. Standard blade cutting edge angle ( A) is 55°. Standard distan ce between the join ts (B) is as show n in th e table Model Standard Us e Range D65EX 1127mm 111 (44.4in) (44 7-1137mm .0-44.8in)