. OPERATION OPERATION REMARK 3 - 142 Method o 1. Remo ve 2 b olts ( 2), then re 2. Insert a bar i n hol e (C) of ro d (1) and turn rod 3. When increasing distance (B) between the j Be sure to set so greas fitting (4) to cover hole (5). o set so since increasin distan ce (B) more can caus e damag e. 4. When decreasing distance (B) between the j oints, set greas fitting (4) to cover hole (6). Be sure t o set so s ince decreasin distan ce (B) more can caus e damag 5. When settin g distance (B) between the joints length , set g rease fitting (4) to cover hole (7). 6.
After completing a djustmen t, use 2 b olts (2) to install cover (3 to its origina When the maximum c utting an gle (blade tilted ful ly forward) is ch anged t o the minimum cutting angle (blade tilted back), the re is r angl become h eavier In this cas e, turn the s tarting sw itch ON (t here is n o need to start t he engine), th en release the work equ ipment lock lever and operat e the blade co ntrol lever to the A ngle position to release the pr essure in the angle cyl