. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 157 Since loading and unloading of the machine is dangerous, be extremely c areful. When loading or unloading the ma chine, operate it slowly with the engine speed low and the transmi Use ramps having sufficient width, length, thickness, and strength. Install them securely and set thei If the ramps are deflected apprecia Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance between the shoulder of the road and the trailer. ge of the machine so that the machine will not slip sideways on the ramps. In addition, il, etc. from the ramps.
Remove mud from the undercarria ge of the machine so that the machin remove water, snow, ice, grease, o Never steer the machine on the ra mps, since steering on the ramps can c ause the machine to tip o ver. If it is necessary to change the travel direction, return to the ground or to the bed of the traile r, then change the travel dir The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero us. Accordingly, pass the border slowly When loading or unloading, alwa ys use ramps or a platform. Procee LOADING WORK l ground only. the edge of a road. 1. 2. 1. Load and unload on firm leve Maintain a safe distance from 2.
Apply the trailer brakes secur ely and put blocks (1) under the tires to hold the trailer in posi tion.Set gap (3) between ramps (2) to match the distance betw een the left and right tracks, and keep angle (4) to a maximum of 15°. If ramps (2) bend appreciably under the weight of the machine, put wooden block (5) under th e ramps to support them. 3. Start the engine. In a cold weather, carry ou t an engine warming-up run, referring to the section, "STARTING IN COLD n this manual. FREE position (F). t gear and run the engine at low the ramps and drive slowly. machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer.
WEATHER (PAGE 3-117)", i 4. Set parking brake lever to the 5. Set the transmission in the 1s t gear and run the engine at low idle. 6. Set the travel direction toward 7. The center of gravity of the border between the ramps unbalanced and becomes da machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the 8. border slowly. Stop the machine at the spec