. OPERATION TRANSPORTATION UNLOADING WORK referring to the section, "STARTING IN COLD (When transporting with work equipment installed) 3 - 159 1. Load and unload on f irm level ground only. M aintain a safe distance from the edge of a 2. Apply the trailer brak es securely and put blocks (1) under the tires to hold the traile r in position.Set gap (3 ) betwe en ramps (2) to match the dista nce between the left and right tr acks, and keep angle (4) to a m If ramps (2) bend app reciably under the weigh t of the machine, put wooden block (5) under the ramps to support th 3. Remove the chains a nd wire ropes fastening the m achine. 4. Start the engine.
In a cold weather, c In arming- WEATHER (PAGE 3 -117)", in this manual. 5. Set main work equip ment lock lever to FREE positio n (F), and raise the work equipm 6. Set parking brake lev er to the FREE position (F). 7. Set the transmission in the 1st gear and run the eng ine at low idle. n toward the ramps and drive slowly. 8. Set the travel directio n toward the ramps and drive slowly. 9. The center of gravity border between the unbalanced and bec of the machine shifts sudde ramps and trailer, and the m omes dangerous. Accordingly nly at achine , pass the is the 10. border slowly. Drive down the ramp s slowly and carefully until the machine fectly. leaves the ramps per