. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 165 BEFORE STORAGE than one month), store as follows. When keeping in long-term storage (more Clean and wash all parts, then store th e machine indoors. If the machine has to be stored outdoors, sel ect level ground and cover the machine with a s heet. ents moisture from collecting. rage. rface of the hydraulic piston rods and the idler adjusting rods. Completely fill the fuel tank.
This prev Lubricate and change the oil before sto Apply a thin coat of grease to metal su rface of the hydraulic piston rods and the idler adjustin Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it se parately. Place all control levers in the neutral p osition, set the work equipment lock lever and parking brake lev er in the LOCK position, and set the fuel control dial to the low idling position. To prevent rust, fill with Komatsu genui ne supercoolant (AF-NAC) to give a density of at least 3 0% for th e engine coolant.
If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors and windows t o improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of oil will coat moving parts. At the same time, also c harge the battery. ipe off all the grease from the hydraulic cylinder rods. When operating the work equipment, w ipe off all the grease from the hydraulic cylinder rods.
If the machine is equipped with an air c onditioner, operate the air conditioner for 3 to 5 minute s once a month to lubricateall parts of the air conditionerc check the refrigerant level twice a year ompressor. Always run the engine at low idle when doin g this. In addition, . NOTICE If the machine has been stored without carryi ng out the monthly rust-prevention operation, consult your Komatsu d istributor before using it. When using the machine after long-term storage, do as follows before using it. cylinder rods. nts. Wipe off the grease from the hydraulic Add oil and grease at all lubrication poi When the machine is stored for a long p eriod, moisture in the air will mix with the oil.
Check the o il before and after starting the engine. If there is water in the oil, change all the oil. STARTING MACHINE AFTER LON G-TERM STORAGE When starting the engine after the machin e has been in storage for a long period, carry out the warming-up o peration thoroughly. For details, see the procedur e in "WARMING UP OPERATIONS (PAGE 3-116)".