Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.

Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%.

When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F).

Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 24 Immediatel y after the e ngine is stopped, the cooling wat er is at hi gh temperature and th e radiator i s under high internal press ure. I f the radiator cap is removed in thi s condition and the wa ter is drained, it may cause burns. To prevent this, wait for the temperature to g o down, then turn the cap slowly t o release t he internal press ure. Start t he engine and cle an the insid e of the c ooling syste m. When standing u p or le aving the operator's seat, set the work equipment lock lever an d parking brake lever to the LOCK position.

For de tails when starting the engine, see "CHE CKBEFORE STARTING ENGINE, ADJUS T(PAGE 3-90)" and "STARTING ENGINE (PAGE 3-111)". at the front of the machine while the engine is running. There is danger of touching the fan.T Never approach the fan at the front o f the ma chine while t he engine i s running. There is danger of touching the fan. Enteri ng under the mach ine for cleaning while the engine i s running i s very dangerous since the machine may start s uddenly. Never enter under the m achine while the engi ne is running .

Stop the machine on lev el ground when cle aning or ch anging th e coolan Clean th e inside of the c ooling system, cha nge the co olant according to t he ta ble below Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoola (AF-NAC) nt Every two years or every 4000 hours whichever comes first 1*