. MAINTENANCE SERVICE PROCEDURE wash it with 4 - 35 CLEAN HYDRAULIC TANK BREATHER (1) at 1. Remove nut (2 ) of breathe hydraulic tank, t hen remove cover (3) 2. Remove dirt stuck to breather clean ligh t oil or detergent o 3. Install cover (3) an d nut (2). Tightening torque: 10 to 14 Nm (1.0 to 1.4 kgm he top of the (4) an 7.2 to 10.1 lbft) CLEAN FUEL TANK BREATHER 1. 2. 3. 1. Remove nut (2) of breather assembly (1) at the top surfac e of the fuel t ank, then r emove c over (3). Remove clean ligh dirt t oil Install cover (3) and nut (2). Tightening torque: 10 to 14 Nm (1.0 to 1.4 kgm 7.2 to 10.1 lbft)