Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE angle. 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. may light up. 4 - 71 9. When installing, bring the packing surface into contact with the seal surface of filter ca rtridge (4) , then ti ghten rther 1/4 -1/2 turns. transparent cap is tightened too mu ch, the O-ring may be damaged, and this will cause leakage o f fuel. not tightened enough, fuel will leak th rough the gap at the O-ring. Always b e sure to tighte n to the spe cified NOTICE When a dding fuel, do not remove cap (B). Alwa small h oles (A) on the dirty side.

After ad ding fuel, remove cap (B) and install the Always fill with clean fuel. Be careful not to let a the fuel. In particular, center portion is the clean cap (B) when adding fuel. Be careful not to let dirt portion on the clean side. 11. When installing, tighten until the packing s urface contacts the seal surface of th e filter h older, t hen tighten it 3/4 of a t If the filter c Wh urn. filter cartridge is tightened too far, th e packing will be damaged and this w ill lead t o leakage of fuel. If the artridge is too loose, fuel will also le ak from the packing, so always tighte n the co rrect en tightening with a filter wrench, be extremely careful not to dent or damage the filter. 12.

Make sure that drain plug, which is provid ed in the lower part of transparent plu g (3), is firmly tightened. Speci fied tightening torque of drain plug: 0 .1 to 0.3 13. Remo ve the vinyl bag covering connector REMARK If wate eparato When removing connector (2), be extreme ly careful not to let water get on the c onnecto If wate r gets on connector (2), dry it compl 14. Turn valve (1) at the bottom of the fuel tan 15. After completing the replacement of filter