. MAINTENANCE SERVICE PROCEDURE 5. Open valves (1) (2 places). CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS 4 - 81 CLEAN BREATH 1. Remove bolts ( 1) of step (2) to remove s tep (2 2. Remove bolts ( 3) to remove cover (4). Remove breath er(5), then use clea REPLACE CORROSION RESISTOR CARTRIDGE Use Komatsu genu ine cartridge 1. 2. 3. 4. 1. Screw in 2 valv es (1) at the top of the co rrosio n resistor. 2. Using a filter wr ench, turn cartridge (2) t o the l eft to remove it. 3. Apply engine oi l to the sealing surface of a new cartridge, then install it to the fi When installing lter holder.
, screw in cartridge until seal comes in contact with sealing sur face, then tighten approx. 2/3 turn. Please ask your Ko matsu distributor to chec k the tightening of the clamps between the air cleaner - turbocharge - aftercooler - engin