. MAINTENANCE SERVICE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT from the circuit, lever to the to each (a) (b) (c) (d) (A) (B) RAISE HOLD LOWER FLOAT RIGHT TILT LEFT TILT 4 - 88 NOTICE Finish th e steps o f operating the blade contr ol lever to the front and back, and to the r ight and left, t o each stroke end within 15 seconds afte r the engine has stopped. After t he engine stops, pressure inside the accumulator begin s to gradually go down, so the pressure cannot b e released excep t right after the engine stops. 1. Lower t he w ork equipme nt an d stop the engine. 2. Tur n th e startin g switch t o the ON p osition 3.
Set the wor k equipment l ock l ever to the FREE position. 4. Operate the blade control leve r fully to the front, rear, left , and righ t to release the pressure fr om th e hydraulic circuit rder elease operate the contro stroke e nd. hydrauli ight an left 5. Set the wor k equipment l ock l ever to the LOCK position.