. OPERATION EXPLANATION OF COMPONENTS HYDRAULIC DRIVE FAN REVERSE MODE CAUTION from is ON, use switches F3 or F4 to select the item, then press switch F6 to confirm. 3 - 48 In th is mode , the fan c annot be rotated in r everse with th e engin e runni Kee p parkin g brake le ver and w ork e quipm ent loc k lever in the L OCK po sition The machine cannot b e driven while the fa n is rotating i n reverse To r elease th e cooling fan from a reverse r otation , turn t he fuel c ontrol dial to the MIN position, the n turn the starting switch to th e OFF p osition an d stop th e engine. Whe n using this mode , carry o ut the warming-up o perati on thoroughly.
If the warming-up operatio n is not carried out, the air flow may be NOTICE When u sing Fa n Reverse for cleaning, use th e following pr ocedure. 1. Ope n both e ngine sid e covers. 2. Use the u ser menu to set the F an Reverse 3. Star t the engine and b low out t he dir 4. Afte r stoppin g the en gine, chec k tha t there is no d irt at a ny place . Be pa rticularly careful to check that there is no dirt on the exhaust manifold or a round the turbochar ode irection norma l when cleaning the radiator core. When the st arting s