EBS00078 CHECKING THE V-BELT 1. Remove: drive belt cover Refer to “PRIMARY AND SECONDARY SHEAVES” in chapter 4. 2. Check: V-belt 1 Cracks/wear/scaling/chipping Replace. Oil/grease Check primary sheave and secondary sheave. 3. Measure: V-belt width 2 Out of specification Replace. V-belt width 31.7 mm (1.25 in) : 31.3 mm (1.23 in) 4. Replace: V-belt MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Install the bolts 1 (90101-06016) into the secondary fixed sheave hold. _ Tightening the bolts 1 will push the secondary sliding sheave away, causing the gap between the secondary fixed and sliding sheaves to widen. NOTE: b. Remove the V-belt 1 from the primary sheave and secondary sheave.
3 - 47 CHECKING THE V-BELT CHK ADJ