3. Adjust: shift control cable shift rod a MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM Shift control cable: a. Make sure that the select lever is in NEU- TRAL. b. Squeeze the brake lever 20 mm (0.79 in) a , loosen the locknut 1 , and then adjust the shift control cable 2 with the adjuster 3 so that the select lever can be shifted to REVERSE from NEUTRAL, and to PARK from REVERSE. c. Release the brake lever so that a is 0 mm (0 in), and then verify that the select lever cannot be shifted to REVERSE from NEU- TRAL, or to PARK from REVERSE. d. If the operation of the select lever is incor- rect, repeat steps (a) to (c). e. Tighten the locknut.
3 1 2 LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM Shift rod: a. Make sure that the select lever and trans- mission are in HIGH. b. Loosen both locknuts 1 . c. Adjust the length a of the shift rod to 413 mm (16.3 in). d. Tighten the locknuts. a 1 e. Start the engine, and then check that the select lever can be shifted to each shift position and that the appropriate indicator light comes on when the lever is in each position. f. Adjust the shift control cable again. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 3 - 58 ADJUSTING THE SELECT LEVER CONTROL CABLE AND SHIFT ROD CHK ADJ T.R. Locknut 15 Nm (1.5 m · kg, 11 ft · lb)