EBS00019 CHECKING THE CONNECTIONS Check the leads, couplers, and connectors for stains, rust, moisture, etc. 1. Disconnect: lead coupler connector 2. Check: lead coupler connector Moisture Dry with an air blower. Rust/stains Connect and disconnect sev- eral times. 3. Check: all connections Loose connection Connect properly. NOTE: _ If the pin 1 on the terminal is flattened, bend it up. 4. Connect: lead coupler connector NOTE: _ Make sure all connections are tight. 5. Check: continuity (with the pocket tester) Pocket tester 90890-03112 Analog pocket tester YU-03112-C NOTE: _ If there is no continuity, clean the terminals. When checking the wire harness, perform steps (1) to (3).
As a quick remedy, use a contact revitalizer available at most part stores. 1 - 11 IMPORTANT INFORMATION GEN INFO