3) If “–05” is stamped on the final drive pinion gear bearing housing, c = 67.8 – 0.05 = 67.75 NOTE: After replacing any part in the final drive pinion gear assembly, the overall length of the assembly will change. Therefore, be sure to measure distance c to select the correct final drive pinion gear shim thickness. c c 4) If “–01” is stamped on the final gear case, d = 100 – 0.01 = 99.99 5) Therefore, “A” is 0.58 “A” = 55 + (67.75 – 22.18) – 99.99 = 0.58 6) Round off the hundredth digit and select the appropriate shim(s). In the example above, the calculated num- ber is 0.58. The chart instructs you to round off 8 to 10 at the hundredth place. Thus, the shim thickness is 0.60 mm (0.024 in).
d Shims are supplied in the following thick- nesses. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 7 - 31 REAR CONSTANT VELOCITY JOINTS AND FINAL DRIVE GEAR DRIV DRIV Hundredths Rounded value 0, 1, 2 0 3, 4, 5, 6, 7 5 8, 9 10 Final drive pinion gear shim Thickness (mm) 0.25 0.30 0.35 0.40 0.45 0.50