2 EBS00418 INSTALLING THE FRONT BRAKE MASTER CYLINDER 1. Install: brake master cylinder 1 brake master cylinder holder 2 1 Lower a UP b NOTE: _ Align the end of the brake master cylinder holder with the punch mark a on the handle- bar. The “UP” mark b on the brake master cylin- der holder should face up. 2. Install: brake hose copper washers union bolt NOTE: _ Tighten the union bolt while holding the brake hose as shown. Turn the handlebar to the left and to the right to check that the brake hose does not touch other parts (throttle cable, wire harness, leads, etc.). Correct if necessary. _ Proper brake hose routing is essential to insure safe vehicle operation.
Refer to “CABLE ROUTING” in chapter 2. WARNING 8 - 19 FRONT AND REAR BRAKES CHAS T. 7 Nm (0.7 m · kg, 5.1 ft · lb) R. rs New T.R. 27 Nm (2.7 m · kg, 19 ft · lb)