4. Install: collar D steering stem joint E steering stem joint bolts F (temporarily tighten) NOTE: Apply LOCTITE ® to the steering stem joint bolts. Align the spline a on the steering stem with the groove b in the steering stem joint. Align the punch mark c on the EPS unit with the groove d in the steering stem joint. 5. Tighten: steering stem bracket bolts G NOTE: Apply LOCTITE ® to the steering stem bracket bolts. steering stem bearing bolts H NOTE: Apply LOCTITE ® to the steering stem bearing bolts. steering stem joint bolts F 6. Tighten: steering stem bolts C e NOTE: Bend the lock washer tab e along a flat side of the bolt. Pass the cable and hoses through the cable guide.
Refer to “CABLE ROUTING” in chap- ter 2. e 8 - 39 STEERING SYSTEM CHAS CHAS b a d c T.R. 50 Nm (5.0 m · kg, 36 ft · lb) T.R. 50 Nm (5.0 m · kg, 36 ft · lb) T.R. 30 Nm (3.0 m · kg, 22 ft · lb) T.R. 23 Nm (2.3 m · kg, 17 ft · lb)