NOTE: Use a remover attachment 3 to separate the ball joint 1 from the steering knuckle 2 . 2 c. Remove the ball joint. 1 3 d. Measure the ball joint bore inside diameter a . Out of specification Replace the steering knuckle. Ball joint bore inside diameter 32.00 ~ 32.05 mm (1.260 ~ 1.280 in) a e. Install the new ball joint. Use the ball joint remover/installer set.
Ball joint remover 90890-01474, YM-01474 Ball joint remover attachment set 90890-01480 Ball joint adapter set YM-01480 Ball joint remover short shaft set 90890-01514 8 - 44 STEERING SYSTEM CHAS CHAS 3 Remover attachment 90890-01474 YM-01474 4 Installer spacer 90890-01480 YM-01480 5 Installer washer 90890-01474 YM-01474 6 Base 90890-01480 YM-01480 7 Body 90890-01480 YM-01480 8 Ball joint remover short shaft set 90890-01514 YM-01514