Komatsu — WORKING NEAR BATTERIES

Safety - Section 20 2/13 OM2049 Page 20-4 WORKING NEAR BATTERIES When removing or installing a battery, positively identify the positive (+) terminal and negative (-) terminal and use precautions not to short circuit between the terminals. Battery Hazard Prevention Battery electrolyte contains sulfuric acid and can quickly burn the skin and eat holes in clothing. If elec- trolyte comes in contact with skin, immediately flush the area with water. This truck is equipped with a master disconnect switch (3, Figure 20-2) on the battery ground circuit. When disconnecting battery cables, always move the master disconnect switch to the OFF position (1, Figure 20-1).

First, disconnect the positive (+) battery cables, then the negative (-) battery cables last. Battery acid can cause blindness if splashed into the eyes. If acid gets into the eyes, flush them immedi- ately with large quantities of water and see a doctor immediately. NOTE: If the master disconnect switch is OFF, and a wrench on the negative (-) terminal touches the battery box frame, a spark will occur if any electrical component on the truck was left in the ON position. If acid is accidentally ingested, drink a large quantity of water, milk, beaten eggs or vegetable oil. Call a doctor or poison prevention center immediately. Always wear safety glasses or goggles when working with batteries.

When connecting battery cables, always move the master disconnect switch (3, Figure 20-2) to the OFF position. Then connect the negative (-) cables first, then the positive cables (+) last. Tighten battery terminals securely. Loose terminals can generate sparks and could lead to an explosion. Tighten battery caps securely. Batteries generate hydrogen gas. Hydrogen gas is very EXPLOSIVE, and is easily ignited with a small spark or flame. Before working with batteries, stop the engine and turn the key switch to the OFF position. Wait two minutes after the engine has stopped, and if no warning lights illuminate, then turn the battery disconnect switches to the OFF position. FIGURE 20-1.

MASTER DISCONNECT SWITCH 1. Off 2. On Avoid short-circuiting the battery terminals through accidental contact with metallic objects, such as tools, across the terminals.