Komatsu — Maintenance

OM3072 2/13 Operating Instructions - Section 30 Page 30-1 CHASSIS SOUND ATTENUATION SYSTEM OVERVIEW General Preparing For Operation Proper service and repair of the sound attenuation components is extremely important for meeting sound power noise targets. Some techniques require the use of tools specially designed for the specific purpose of servicing the machine. Before carrying out any servicing or repairs, read all the safety labels attached to the machine. For the locations of the safety labels and detailed explanation of the precau- tions, refer to the truck Operation and Maintenance Manual. The safest trucks are those which have been prop- erly prepared for operation.

At the beginning of each shift, a careful check of the truck must be made by the operator before starting the engine. Safety Is Thinking Ahead Prevention is the best safety program. Prevent a potential accident by knowing the employer's safety requirements, all necessary job site regulations, as well as use and care of the safety equipment on the truck. Only qualified operators or technicians can operate or maintain a Komatsu truck. Maintenance Refer to the Sound Attenuation System Service Inter- vals section for scheduled maintenance intervals. Safe practices start before the operator gets to the equipment! Wear the proper clothing.

Loose fitting clothing, unbuttoned sleeves and jackets, jewelry, etc., can catch on a protrusion and cause a potential hazard. Always use the personal safety equipment provided for the operator such as hard hats, safety shoes, safety glasses or goggles. There are some conditions when protective hearing devices must also be worn for operator safety. Do not pressure wash the sound attenuation sur- faces. Malfunction and damage may occur, reducing the effectiveness of the attenuators. When walking to and from the truck, maintain a safe distance from all machines, even if the operator is visible. Measure sound levels of machine during work every 10,000 hours.

The sound levels will depend upon the specification of the attenuation kit. If the reading is greater than specified, thoroughly inspect all sound attenuation parts for damage or incorrect installation, fixing where necessary. If this does not lower the sound level to an acceptable level, replace perfo- rated sheeting and acoustic insulation on applicable panels. Always use the specified absorption material, use of inappropriate material may reduce effective- ness and increase risk. Components This document gives instructions about the mainte- nance of a sound suppression kit for an 830E-1AC rear dump truck. There are up to 12 main parts to the system (depend- ing upon specification):

Engine side panels Engine belly pan Radiator attenuator For replacement parts or part numbers, refer to the parts book for the sound attenuation kit. Rear-exiting exhaust Rear engine compartment enclosure Centre deck lining Front panel assembly below radiator attenuator Grille and hood seals Alternator air intake silencer Retarding grid attenuation package Upper horse collar panels Blower duct cover and hoses