. OPERATION OPERATION WHEN TIRES ARE STUCK IN GROUND the procedure below, use a bulldozer to tow the machine out. 3 - 105 (A): Manual actu ation of inter-axle loc Use this whe n operating in places where th Cancel this w hen operating on har d ground REMARK It will become m ore difficult to turn than when t he differential lock i s not used. Accordingly, take care during turning. (B): Manual actu ation of inter-axle diff erential l ock, and actuation of center, rear axle left a nd right differential l ock Use this setti ng when traveling in ( A) and t he machine gets st uck or the tires start to sl ip on sof t ground . Depress the differential lo canceled.
REMARK differential lock pedal at the s ame time as actuat ing the left and right diffe rential lo ck s witch. The ck will be actuated only while the pedal is being depressed. When the pedal is released, it is is When the left and right differential l ock is a ctuated, the steerin g wheel will become mo re difficu lt to operate , so be particularl y careful when travelin g aroun d sharp curves. (C): Manual actu ation of inter-axle diff erential l ock, and actuation of front, center, rear axle left and right differential lock n the maximum rim pull is needed.
Use this whe n the maximum rim pu REMARK When the left and right differential l ock is a ctuated, the steerin g wheel will become mo re difficu lt to operate , so be particularl y careful when travelin g aroun d sharp curves. If the wheels ge t stuck, to stop the wh eels fro m spinning, do as f If it is impossibl 1. Release the accelerator pedal to s top the wheels from spinni ng. t differential locks. 2. Actuate the inter-axle differential l ock and all the left and righ t differential locks. 3. Depress the left and right different ial lock pedal, set to the ge arshift lever to position " 5", and r aise the engine speed. accelerator pedal and brake pedal. 4.
Release the accelerator pedal and brake 5. Depress the left and right differenti al lock p edal, set to the gea r shift lever to position "R 1", and r aise the engine speed. s 1 - 5 to move the machine backwards and forwards until it can escape. 6. Repeat step s 1 - 5 to move the m achine b ackwards and forw ards until it can escape.