Komatsu — METHOD OF LIFTING MACHINE

. OPERATION TRANSPORTATION METHOD OF LIFTING MACHINE WARNING Never try to lift the machine in any posture other than the posture the procedure below or using lifting equipment other than in the procedure below. There is a hazard that the machine may lose its balance. Consult your Komatsu distributor before performing lifting work. 3 - 120 When lifting the machine at a port or any other place, always us e the following p rocedure to lift it. The operator performing the lif ting operation using a crane must be a properly qualified crane operator.

Never raise the machine with a Always make sure that the wir e rope is of ample strength for the weig ht of this machine When lifting, keep the machine Before starting the lifting oper ation, always stop the engine, appl y the parking brake, an d use the articulation lock to prevent he front frame from articulatin Never enter the area around or given in NOTICE he standard specification machine. rding to the attachments and options installed.

Thi s method of lifting applies to t he standard specification machine The method of lifting differs acco rding to the attachments and options i For details of the procedure for m achines that are not the standard specification, consult y our Komatsu distributor. Fo r the weight of the standard specification machine, see "WEIGHT TABLE (PAGE 3-121)". NOTICE Use protectors to prevent the wire rope from being cut on sharp corners and to preve nt the wire rope from cutting into the machine bodywork. lect an ample width to prevent contact with the machine. When using a spreader bar, se lect an ample width to prevent contact with the machine.