. MAINTENANCE GUIDES TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance performed. KOMATSU GENUINE OILS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. OIL CHANGE: 4 - 2 GUIDES TO M Do not perform any in spection and maintenance operation that is not found in this o be KOMATSU GENUINE RE PLACEMENT PARTS: Use Komatsu genuine parts specified in the Parts Book as repl ALWAYS USE CLEAN W ASHER FLUID: Use automobile windo w washer fluid, and be careful not to let a ALWAYS USE CLEAN OI L AND GREASE:
Use clean oil and grea se. Also, keep the containers of the oil an d grease clean. Keep foreig n materials a way from oil and grease. CHECKING FOREIGN MATERIALS IN DRAINED OIL AND ON FILTERS: After changing the oil or replacing the filter, check the drained oi l and filter for metal particles and foreign materials. If large quantities of m etal particles or foreign materials are found , always report to the person in charge an d perform suitable action. In ad install it. dition, when replacing the engine oil filter, fill the new filter with the specified clean oil, then pecified clea then If your machine is equ ipped with a fuel strainer, do not remove WELDING INSTRUCTION S: starting switch.
han 200 V continuously. Turn off the engine Do not apply more t Connect grounding the cable within 1 m (3.28 ft) from the ar ea to be welded. Connecting grounding c able near meters and connec tors will lead to the failure of meters. If a seal or bearing happens to come between the part being welded and grounding point, change the grounding point to avoid such parts. around the pins or the hydraulic cylinders as the grounding point. amage to the plated portion. Do not use the area around the pins or the hydraulic cylinder s as the grounding Sparks will cause d amage to the plated portion. DO NOT DROP THINGS I NSIDE MACHINE:
When opening insp ection windows or the oil filler port of the ta nk to perform inspection, be c arefu l not to drop nuts, bolts, or tools inside If such things are dr lead to failure. If yo the machine. opped inside the machine, it may cause d amage and/or malfunction o f the machin e, and will u drop anything inside the machine, alwa ys remove it immediately. or inspection. Do not put unneces sary things in your pockets. Carry only t hings which are necessary f or inspection