Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK OF INFLATION PRESSURE OF TIRES AND INFLATION OF THEM WARNING NOTICE If the tires are used when the inflation pressure is less than the value given in the table above, the rim may be damaged. Always keep the tire inflation pressure within +0 to +0.03 MPa (0.3 kg/cm 2 , 4.3 PSI) of the value in the table above. 4 - 38 When inf lating the ti re, check tha t no one can ente r the area ar ound the tire, and always use an air chuck with a clip that c an be fixed to the air valve. While infl ating the tir e, check the i nflation pressure occasional ly so t hat it will not rise too hi gh.

If the rim is not fitted normally, it may be broken an d scattered while the tire is inf lated. Accordingly, plac e a guard around the tire an d do not work in f ront of the r im but work on the tread side of the tire. f the rim Abnorma l drop of i nflation pres sure and abnorm al fitting o rim indicate a trouble in the tire or r be sure to ask a tire repair sh op for repai Be sure t o observe t he specified inflation pressur Do not a djust the in flation press travel or heavy-load work. Check Measure t he inflation pressure w ith a tire press ure gauge , whil e the tires are cool, before s Inflation of t ires inflation pressure properly.

Adjust the inflation p ressure pro When infla ting a tire, use an air chuck which ca n be fixed to th e air valve of the tire as sho wn in the figure. Do not work in fro nt of the ri m but work on the tread si de of the ti The prope r inflation pressure is shown below. Tire size Inflation pressure [MPa (kg/cm2, PSI)] 29.5-R25 VLT (standard) 29.5-R25 VKT (standard) 0.37 (3.8, 54.0) 29.5-R25 XADT (standard) 0.39 (4.0, 56.8) 29.5-R25 RL2+ (standard) 0.40 (4.1, 58.2) 875/65 R29 (if equipped) 0.44 (4.5, 63.9)