Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECKING AND ADJUSTING OF DUMP BODY MOUNT WARNING 4 - 40 When performing inspection of the machine with the dump body raised, always set the d ump le ver to HOLD p osition, lo ck with the dump lever lo ck knob, then use the b ody piv Check and adju st the dump body mount be cause the frame m ay be damaged if it is n ot adjusted CHECKING ump body and frame to make it easier to check. 1. 2. 1. Clean the d ump body an d frame to ma ke it easie r to chec 2. Check that bottom mount (1) of body contacts to frame top evenly. rame surface (2) Check all of 6 places on the righ t and le ft of (A), ( B), and (C). ADJUSTING 1. 2. 1.

If there is an y clearance ( D) between the bottom m ount (1) and the top surf ace (2) of the frame, adjust the bottom mount with shims. r Komatsu distributor for the adjustment. ody, and check that all of 6 places of the bottom act to frame top surface (2) evenly. Contact you r Komatsu di stributo r for th e adjustment. 2. Lower the b ody, and ch eck that all of mount cont act to frame t op surface (2) evenly