. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REMARK Steps 6 to 8 are identical with those in "CHANGE OIL IN TRANSMISSION CASE (PAGE 4-68)". NOTICE in the brake oil tank. REMARK Steps 9 through 11 are identical with those in "CHANGE OIL IN TRANSMISSION CASE (PAGE 4-68)". 4 - 71 Do the not start up the engine without th engine is started up while the tran transmission hydraulic pump will suf 6. Before starting the engine, a dd 90 liters (23.78 US gal) of oil through oil filler port (F). When oil is added, the level w ill temporarily go above the oil level on sight gauge (G), b any abnormality. w idle. 7. Start the engine and run at lo 8.
Add oil through oil filler port ( F) until the oil level is between the H and L marks on sigh Make sure that the oil level in the brake oil tank does not go down below the mark in th the engine is running at low id le. If the oil level goes down below (H) mark, stop the engi 9. Perform the warming-up ope ration of the engine until the torque converter oil tempera 40°C (104°F). 10. When the torque converter o il temperature gauge rises to 40°C (104°F), bleed the air Front brake: See "BLEED AI R FROM FRONT BRAKE (PAGE 4-33)". IR FROM CENTER BRAKE (PAGE 4-34)". R FROM REAR BRAKE (PAGE 4-35)". Center brake: See "BLEED A Rear brake:
See "BLEED AI NOTICE D o not attempt to use the oil drain ed during air bleeding again. Such a practice can cause damage e quipment. M ake sure that the oil level in the brake oil tank does not go down below (H) level in the sight gau d oes, the brake oil pump could be damaged.