Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF BRAKE DISC WARNING it depressed, and push in the rod (2) enters beyond guide end wear limit, ask your Komatsu 4 - 75 Perform this check when the brake o I f the disc wear approaches the wear limit, check the condition frequently, regardless of the mainten ance interval. In addition, check the retarder capacity carefully 1. Stop the machine on level groun d, set the parking brake switch to PARKING position, th en check that the other brakes are not applied before s tarting inspection. check that the retarder oil pressure caution lamp is out. 2.

Turn the starting switch ON and check that the retarder oil pressure caution lamp is out I f the retarder oil pressure cauti on lamp is lit, start the engine, run the engine at 2000 rp m, and if the lamp goes out, turn the starting switch OF F. 3. 4. Depress the brake pedal, keep r od (2) of the gauge until conta 5. I f mark (3) at position "A" of ro f I ace (4), it means that the disc f the disc has reached the w distributor for inspection and m 6. Tighten cap nut (1) removed in Tightening torque: 14.7 to 19.6 (1.5 to 2.0 k Tightening torque:

14.7 to 19.6 REMARK With new machines, the position of the guide is adjusted so that mark (5) comes to end f ace (4) of the guid e, so d o not loosen locknut (6) except when replacing the disc. Perform the operation with two w orkers. One worker depresses the brake pedal and the o ther pushes in the rod. If the rod is pushed in when the e ngine is running, the rod will be pushed back by the brak e cooling oil pressure, s o always perform this operation with the engine stopped. ree places (A, B, C), but on this machine, use the mark at position A. There are marks on the rod at th ree places (A, B, C), but on this machine, use the mark