Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE Front Rear the ball joints. 4 - 82 12. After the lubrica nt is dried out, install ball j oint and exhaust bellows in the reverse order to removal. l spring (1 9) and doub le nuts (9 ) and (11 ) according to the procedure shown in the following fi gure. How to ti ghten the d ouble nut Fix nut (8 ) by using a wrench s o that the length of spring becomes length (C ) shown in the figure above. o 61mm torque 98 to 123 Nm {10 to 12.5 d by the wrench. Length ( C) of spring (19 ) : 59 t Tighten n ut (D) wit h tightening torque 9 kgm} whi le nut (B) i s being fixe d by the wrenc Nm {1 13.

Chec k that exhaust gas is not leakin g, and bal l joints rotate smoothly without seizure or locking afte r installing