. ATTACHMENTS, OPTIONS HANDLING MACHINES EQUIPPED WITH KOMTRAX BASIC PRECAUTIONS WARNING 6 - 51 HANDLING MACHINES EQUI PPED WITH KOMTRAX m that uses wireless communications. KOMTRAX is a machine management syste A contract with your Komatsu distributor is ne cessary before the KOMTRAX system can be used. Any customers desiring to use the KOMTRAX system shou ld consult their Komatsu distributor. The KOMTRAX equipment is a wireless dev ice using radio waves, so it is necessary to obtain authorizatio n and conform to the laws of the country or territory contact your Komatsu distributor before selli where the machine equippedwith KOMTRAX is being used.
Al ways ng or exporting any machine equipped with KOMTRAX. When selling or exporting the machine or at other times when your Komatsu distributor considers it necessary, it may be necessary for your Komatsu distrib communications. If you do not obey the above precaution utor to remove the KOMTRAX equipment or to perform action t o stop s, neither Komatsu nor your Komatsu distributor can take any or for any loss that results. responsibility for any problem that is caused Never disassemble, repair, modify, or move the c ommunications terminal, antenna, or cables. This may cause failure or fire on the KOMTRAX equipment or the machine it KOMTRAX.) self.
(Your Komatsu distributor will perform removal and installation of Do not allow cables or cords to become caught; d o not damage or pull cables or cords by force. Short circuits or open circuit wires may cause failure or fire on the KOMTRAX e quipment or the machine itself. For anyone wearing a pacemaker, make sure that the communications antenna is at least 22 cm (8.7 in) from the pacemaker. The radio waves may have an adverse effect on th e operation of the pacemaker.
Near the blasting jobsite, there may be a danger of unexpected explosion due to use of interactive wireless communication device of KOMTRAX and resulting serious person If you have to operate the machine within 12 m ( Komatsu distributor to disconnect power source If there are any restriction or law of the territory restriction or law has a priority than this warning. KOMTRAX specifications are as follows. Rated transmit power: 5 to 10 W Transmit frequency: 148 to 150 MHz al injury. Make sure to operate the machine away from the blasting jo bsite. 39 ft 4 in) from the blasting jobsite or the remote blasting device, as k your cable of KOMTRAX in advance.
or country where the machine equipped with this device is used, such NOTICE Even when the key in the starting switch of the KOMTRAX system is at OFF position, a small amount of electric power is wer is consumed. When putting the machine into long-te rm storage, take the action given in "LONG-TERM STORAGE (PAGE 3- 127)". Contact your Komatsu distributor before installin g a top guard or other attachment that covers the cab roof. s terminal or wiring.
Be careful not to get water on the communication REMARK The KOMTRAX system uses wireless comm unications, so it cannot be used inside tunnels, underground, i nside buildings, or in mountain areas where radio cannot be used in areas where the radio sig area. waves cannot be received. Even when the machine is outs ide, it nal is weak or in areas outside the wireless communication se rvice There is absolutely no need to inspect or ope rate the KOMTRAX communications terminal, but if any abnormality is found, consult your Komatsu distributor.