Komatsu — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS STARTING SWITCH 3 - 31 This switch (1) is us ed to start or stop the OFF position : At this position, the s tarting switch key can be insert ed or removed. When the key is tur ned to this position, a ll the elec tric circuits are switched off and the engine stops. ON position : In this position, ele circuits. Keep the starting s running. ctric current flows in the charging and lamp witch key at ON position while the engine is When turning the st arting switch ON or O FF, if the starting sw itch is held at a positio n between ON and OFF, the controller may detect this as a prob lem.

If this happens, r eturn the starting sw itch to OFF position, the n operate it as usual to ON po sition. In cold weather, if th e starting switch is tu rned to O N position, pre-heating is automatical ly started and the engine pre-heating pilot lam p lights up. After the pre-heat ing is completed , the engine pre-heati ng pilot lamp goes out. START position : This is the position to start the engine. Hol d the key at this positi on while cranking. Release the key immediately after the engine has bee n started. The key will return to ON positio n when released.

LAMP SWITCH This switch (2) lights up the head lamps, s ide clear ance lamps , tail lamps, machine mo nitor lighting, and rear Position (a): OFF Position (b): Side cl machin Position (c): Front la e monitor lighting ligh mps light up in additio The lamp switch ca n be operated regardless of the position of the lever. TURN SIGNAL LEVER tes the turn signal lamp. the lever forward e lever back This lever (2) opera tes the turn signal lam (a)Right turn: Push (b)Left turn: Push th When the lever is op erated, the turn signa l pilot lam p also flashes. The lever is autom atically returned whe n the ste ering whe turned back. If the l ever does not return, move it b