Komatsu — PANEL GAUGES, INDICATORS, AND CONTROLS (DISCUSSION OF ITEMS 1-29, FIGURE 3-6)

OM3003.3 Operation - Section 3 Instrument Panel & Indicator Lights Page 3-27 PANEL GAUGES, INDICATORS, AND CONTROLS (Figure 3-6) (1, Figure 3-6) KEY SWITCH The key switch is a 3-position (Off, Run, Start) switch. When switch is rotated one position clockwise, it is in the "Run" position and all electrical circuits (except "Start") are activated. With Selector Switch in " N eutral", rotate keyswitch fully clockwise to "Start" position and hold this position until engine starts. "Start" position is spring loaded to return to "Run" when key is released. With truck stopped, turn keyswitch counterclockwise to "Off" for normal engine shutdown.

Use Engine Shutdown switch on center console, if engine does not shutdown with keyswitch. NOTE: A ground level shutdown switch is located on lower front left side of truck. (2, Figure 3-6) ENGINE SHUTDOWN SWITCH with TIMER DELAY This is a 3-position rocker-type switch (Off-On-Momentary). 1. Press top of switch to the "On" (center position), then press firmly to the "Momentary" (upper position) and hold briefly to activate the 5 Minute Idle Timer (switch is spring- loaded to return to "On" position when released). 2.

When the Engine Shutdown Timer has been activated, the Timer Delay indicator light in the overhead status panel will illuminate to indicate that the shutdown timing sequence has been started. The engine will continue to run at Idle RPM for approximately 5 minutes to allow for proper engine cool-down before stopping. 3. The Engine Shutdown Timer switch DOES NOT turn off 24 VDC electric power . Turn Keyswitch counterclockwise to the "Off" position to cause the engine to shutdown when timing sequence is complete. When engine stops, this will activate the hydraulic bleeddown timer and turn off the 24 VDC electric circuits controlled by the keyswitch. NOTE:

To cancel the 5 Minute Idle Timer sequence, press Timer Delay Shutdown switch to the "Off" (lower position). If keyswitch (1) is in "Off" position, engine will stop. If keyswitch (1) is in "On" position, engine will continue to run . (3, Figure 3-6) MANUAL BACKUP SWITCH The Manual Backup Switch allows backup lights to be turned "On" providing added visibility and safety when the Selector Switch (see OPERATOR CONTROLS) is not in "REV" position. When the SWITCH is pressed toward the "on" position, the MANUAL BACK UP LIGHT indicator (B4, Overhead Panel) will be illuminated. (4, Figure 3-6) LADDER LIGHT SWITCH The switch turns the ladder lights "On" or "Off" after or before using ladder.

Pressing the top of the rocker switch turns the lights "On". Pressing the bottom of the switch turns the lights "Off". Another switch is mounted at the front left of truck near the base of ladder.