Komatsu — INDICATOR LIGHT SYMBOLS - REFER TO FIGURE 3-7 BY ROWS (A-E) AND COLUMNS (1-6)

OM3003.3 Operation - Section 3 Instrument Panel & Indicator Lights Page 3-37 A4. NOT USED Reserved for future use or options. B4. Manual Backup Lights This amber indicator will illuminate when the manually operated Manual Backup switch (3, Figure 3-6, Instrument Panel) is turned "on". C4. Engine Shutdown Timer - 5 Minute Idle When the Engine Shutdown Timer switch has been activated (2, Figure 3-6, Instrument Panel), this indicator light will illuminate to indicate that the shutdown timing sequence has started. Refer to Instrument panel for operation of this switch. This amber light is illuminated when the RSC switch mounted on the console is pulled out to the "On" position.

The light indicates the retarder is active. It is for feedback only and does not signal a problem. D4. Retard Speed Control Indicator This amber "Check Engine" indicator will illuminate if a malfunction is detected by the MTU engine electronic control system. If this indicator illuminates, truck operation may continue, but maintenance personnel should be alerted as soon as possible . E4. Check Engine There are several "faults" that can illuminate this light: ECS (governor) failure. Start Interlock; if the temperature of the engine lube oil is below 0°C (32°F), the starter can not be engaged. Low engine lube oil pressure pre-warning. Water/Fuel prefilter. High Coolant Temperature.

Turbocharger Overspeed; if turbocharger overspeeds, the fuel rack control will be cut back slighly until the turbocharger recovers, and then full fuel rack control will be available again.