Komatsu — 10 HOUR (SHIFT) LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4003.1 03/01 Page 4-4 Lubrication & Service 10 HOUR (DAILY) INSPECTION Prior to each operating shift, a “walk around” inspec- tion should be performed. Check the truck for general condition. Look for evidence of hydraulic leaks; check all lights and mirrors for clean and unbroken lenses; check operator’s cab for clean and unbroken glass; check frame, sheet metal and body for cracks. Notify the proper maintenance authority if any discrepancies are found. Give particular attention to the following: Truck Serial Number ____________________________ Site Unit Number ______________________________ Date:______________Hour Meter_________________ NOTE:

"Lube Key" references are to the Lubrication Specification Chart. Name of Service person_________________________ 10 HOUR LUBRICATION AND MAINTENANCE CHECKS 1. FAN DRIVE AND TURBOCHARGERS - Check for leaks, vibration or unusual noise. Check alternator and fan belts for proper tension, condition and for alignment. 2. RADIATOR - Check coolant level and fill with proper mixture as shown in Cooling System Recommen- dation Chart. Refer to Engine Manual for proper coolant additives. 3. ENGINE - Check oil level. Refer to engine manufacturer’s Shop Manual for oil recommendations. (Lube Key "A"). Inspect exhaust piping for security. 4. FUEL FILTER - Drain water from bottom of filter housing. 5.

FUEL STRAINER - Drain water and sediment at drain cock. 6. MOTORIZED WHEELS - Refer to G.E. Motorized Wheel Service & Maintenance Manual for lubrica- tion specifications and service intervals. 7.HYDRAULIC TANK - Check oil level in tank, add if necessary. Refer to "Hydraulic Tank Service". Oil should be visible in sight glass. - DO NOT OVERFILL. Lube Key "B". 8. FUEL TANK - Fill as required. 9. BATTERIES (NOT SHOWN) - Check electrolyte level and add water if necessary. 10. AIR CLEANERS (NOT SHOWN) - Check air cleaner vacuum gauges in operator cab. The air cleaner(s) should be serviced, if the gauge(s) shows the following maximum restriction: MTU Engine: 14 in. of H 2 O vacuum*.

See Section "C" of the Shop Manual for servicing air cleaner elements. Empty air cleaner dust caps. NOTE: After service, push the reset button on face of gauge to allow the gauge to return to zero. COMMENTS √’d INITIALS