Komatsu — 50 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4003.1 03/01 Page 4-6 Lubrication & Service 50 HOUR LUBRICATION AND MAINTENANCE CHECKS MOTORIZED WHEELS - Check for correct oil level. Refer to G.E. Motorized Wheel Service & Maintenance Manual for lubrication specifications. These checks are required only after the first 50 , 100, and 250 hours of operation (such as: new truck commissioning, or a new/rebuilt component installa- tion), check: 1. ENGINE - Change engine oil and lube oil filter elements after the initial 50, 100, and 250 hours of operation; then at each 250 hours of operation thereafter. Lube Key "A". NOTE:

When installing spin-on filter elements, thread onto base until the seal touches the base and then tighten only 1/2 to 3/4 additional turn by hand to seat element fully. Do not use a wrench or strap to tighten filter elements. 2. FAN - Check the torque for the fan mounting capscrews - 31 ft.lbs. (42 N.m) for MTU engine. 3. HYDRAULIC SYSTEM FILTERS - Replace filter elements only, after the initial 50, 100, and 250 hours of operation; then at each 500 hours of operation thereafter. Truck Serial Number ___________________________ Site Unit Number ______________________________ Date: Hour Meter ______________ _________________ Name of Service person ________________________ COMMENTS √’d INITIALS