Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4003.1 03/01 Page 4-8 Lubrication & Service 250 HOUR LUBRICATION AND MAINTENANCE CHECKS Truck Serial Number ____________________________ Maintenance for every 10 & 50 hour Lubrication and Maintenance Checks should also be carried out at this time. NOTE: "Lube Key" references are to the Lubrication Specification Chart . Site Unit Number ______________________________ Date:______________Hour Meter_________________ Name of Service per- son__________________________ 1. ENGINE - Change engine oil and replace lube oil filters. Lube Key "A". NOTE:

When installing spin-on filter elements, thread onto base until the seal touches the base and then tighten only 1/2 to 3/4 additional turn by hand to seat element fully. Do not use a wrench or strap to tighten filter elements. 2. HYDRAULIC SYSTEM FILTERS - Replace filter elements only after the initial 250 hours of opera- tion; then at each 500 hours of operation thereaf- ter. Check oil level. Add oil as necessary. Lube Key "B". 3. FUEL FILTERS - Change Primary Fuel Filter, Sec- ondary Fuel Filter, and Fuel Separator. 4. MOTORIZED WHEEL GEAR CASE - Refer to the G.E. planned maintenance manual and specific motorized wheel Shop Manual. 5.

HYDRAULIC PUMP DRIVESHAFT & U-JOINTS - Add one or two applications of grease to each grease fitting. Check that each bearing of the Cross & Bearing assembly is receiving grease. Lube Key "D". 6. COOLING SYSTEM - Check cooling system for proper coolant mixuture. Add water as required. 7. REAR WHEEL MOUNTING - Using a mirror on a long rod and a flashlight, inspect where possible, all inner and outer wheel mounting nuts/studs for any evidence of looseness, damage, or missing hardware. If wheel mounting nuts/studs must be secured/re- placed, outer wheel must be removed for access. Refer to Shop Manual, Section "G", for these pro- cedures. Tighten wheel mounting nuts to 1580 ± 150 ft.lbs.

(2140 ± 203 N.m) torque. 8. STEERING LINKAGE - Check torque on pin retain- ing nuts (steering linkage), 525 ft.lbs. (712 N.m). Check torque on tie rod retaining capscrews, 310 ft.lbs. (420 N.m). 9. MAGNETIC PLUG - Remove magnetic plugs from front hub covers and inspect. Clean the plugs and perform any necessary repairs. COMMENTS √’d INITIALS