OPERATION FUSES AND RELAYS — ACCESSORIES The fuses and relays are below the steering wheel inside the front dash- board. Removing the cover (1) exposes the fuses and relays, if service is required. If an electrical system fails, check the fuses and relays first. Each fuse bank is set-up with a red LED indicator to alert the operator or techni- cian of a blown fuse in a that bank. The relay bank has a yellow LED to indicate a defective relay. After removing the cover (1), the fuses and relays are easily accessible. With the ignition key to the “ON” position, look and see if any LED is on. Before replacing a fuse or relay, turn the ignition switch to the “OFF” position.
Remark When replacing fuses or relays always check the contacts for corrosion. If the panel is badly corroded, contact your Komatsu Dealer for repair. Never replace a fuse with a fuse of higher or lower amp rating. Damage to the electrical sys- tem may result. FUSE AND RELAY GRID 2-32 WB140PS-2N WB150PS-2N