Komatsu — WARMING UP THE MACHINE

OPERATION After the preheat is complete, depress the accelerator half way, or fully depressed in extremely cold weather; do not pump the accelerator pedal. Crank the engine until it starts. When the engine starts, release the key and accelerator pedal. The switch automatically returns to the “ I ” position. With the engine now running, check all the gauges. None of the warning lights should glow while the engine is running. If any warning lights glow, make the needed repairs before starting work. Allow the engine and hydraulic system to warm up before starting work. Remark If the engine fails to start within 15 seconds, release the igni- tion switch. Wait 30 seconds before trying again.

If the engine will not start, do not continue to crank the engine or starter damage may result. Contact your Komatsu Dealer for repairs. WARMING UP THE MACHINE In cold weather, warm up the engine and the hydraulic oil before mov- ing the machine. Starting work operations with a cold machine causes unnecessary parts wear. To warm up the engine and hydraulic oil: 1. Unlock the loader control lever (3). 2. Set the throttle at a 1/4 above low idle. 3. Raise and lower the loader boom while operating the bucket. Do this step several times to warm up the engine oil and hydraulic oil. Remark Do not accelerate or rev the engine at high speeds when cold, or damage to internal engine parts may result.

2-40 WB140PS-2N WB150PS-2N