Komatsu — PLANETARY

MAINTENANCE CHANGE THE REAR AXLE OIL Oils, filters, coolant, and the battery are considered special waste and must be collected and disposed of according to all anti-pollution regulations. Perform this operation with the machine positioned on level ground. Drain the oil at operating temperature, so that any particles suspended in the oil drain with the oil. DIFFERENTIAL 1. Using a 1/2 in. square wrench, remove the drain plug (2) and fill plug (1). Opening the fill plug (1) acts as a vent, which allows the oil to drain faster into a container with suitable capacity. 2. After draining the oil, reinstall the plug (2). 3.

Pour fresh oil of the prescribed type through the hole (1) until the oil level is at the lower edge of the hole (1). # Both axle shafts are filled with oil. Before checking the differ- ential oil level and installing the plug wait a few minutes to permit the uniform distribution of oil. 4. Install the plug (1). PLANETARY 1. Move the machine until the drain plug (3) is at the low end of the vertical axis (6 o’clock position). 2. Using a 1/2 in. square wrench, remove the plug (3) and let the oil drain into a container with suitable capacity. 3. After draining oil, move the machine until the plug (3) is positioned on the horizontal axis (3 or 9 o’clock position). 4.

Pour oil of the prescribed type through the hole (3) until the oil reaches the lower edge of the hole (3). 5. Reinstall the plug (3). Move the machine both forward and backward and then stop it. Check the levels again. Always use oil of the prescribed type. 3-54 WB140PS-2N WB150PS-2N