MAINTENANCE CLEAN THE WATER SEPARATOR 1. Loosen the screw (1) and drain the water from the separator into a container with suitable capacity. Use a 13 mm wrench. 2. Loosen the central screw (2). 3. Remove the bowl (3) and filter element (4). Use a 14 mm wrench. 4. Clean the inside of the pan and filter with diesel oil or oil. 5. Reinstall the filter (4) and bowl (3). 6. Tighten the screws (2 and 1). 7. Bleed the fuel supply circuit. See “CHANGE THE FUEL FILTER” on page 3-50. # Replace a clogged or damaged filter element. 8. Start the engine. CHECK AND ADJUST THE FRONT WHEEL TOE-IN The front wheel toe-in changes because of impacts or vibrations.
The toe-in must be checked periodically to prevent the front tires from wear- ing excessively. Check the condition of the tie rod end (3) on each side of the machine before measuring the front wheel toe-in. Shake the joint (3) with your hand. If the end (3) is excessively loose, replace it before taking the measurement. The machine has been designed with a toe-in equal to 0 mm. If the mea- surement exceeds this specification, loosen the locknuts (2) with 27 and 19 mm wrenches. Split the measurement difference evenly between the right and left sides when making the adjustment. Turn the tie rod (1) on the left and right sides to obtain the specified 0 mm. 3-68 WB140PS-2N WB150PS-2N