OPTIONAL ATTACHMENTS OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW When certain optional equipment is installed on the machine, it cannot be driven on any roads. Check with local authorities if in doubt. A machine that cannot be driven on the roads requires the optional equipment attached at the work site. The equipment must be once again removed before travelling on the road. Optional equipment can be installed on the backhoe in place of the standard bucket. A pedal (1) to the left of the backhoe levers con- trols the hydraulic circuit from the additional hydraulic distributor. Pressing the front part of the pedal delivers hydraulic oil to the right side of the circuit.
The oil returns through the left side. Pressing the rear part of the pedal delivers hydraulic oil to the left side of the circuit. The oil returns through the right side. The function of the backhoe levers remains unchanged, except for the bucket movement. What once controlled the bucket position now controls the optional equipment position. INSTALLING AND CONNECTING THE EQUIPMENT While making the hydraulic connections, prevent dirt or other foreign objects from entering the hydraulic lines. Check the hydraulic system for leaks with a piece of cardboard, and wear thick gloves and goggles. See “CHANGING THE BACKHOE BUCKET” on page 2-54 to install the equipment. 1.
After connecting the equipment, stop the machine. 2. Press the pedal (1) forward and backward several times to release any residual hydraulic pressure. 3. Remove the plugs in the two pipes and of the installed equipment. 4. Connect the delivery and return pipes. 5. Start the machine. 6. Perform several maneuvers that require the pedal (1) to be pressed forward and backwards. 7. Stop the machine. 8. If needed, fasten the longer pipes to avoid vibrations. WB140PS-2N WB150PS-2N 5-29