Mack Trucks — Mack TerraPro LEU Series Operation Manual

OPERATION 131 Work Brake System The work brake system is designed to be used when frequent stops are made. This type of operation, typical in house-to-house refuse collection, consumes large volumes of air if the spring brake is applied at each stop. The work brake system uses significantly less air volume than the spring brake system, improving overall brake system durability. In addition, the brake system incorporates backup features which apply the spring brakes in the event of an engine shutdown or significant loss of air pressure.

With the work brake applied, spring brake application will occur if the engine should be shut off or if a loss of air pressure is detected in the primary system. Operating the Work Brake System Note: Always use the foot brake to bring the vehicle to a complete stop before applying the work brake. In normal operation, when the work brake is applied, the transmission will be shifted into neutral from a forward or reverse gear and both the front and rear axle service brakes will be applied. When the vehicle shifts to neutral from the reverse gear, the transmission must be manually shifted back into gear.

Work Brake Application from a Forward Gear To apply the work brake and place the automatic transmission in NEUTRAL: 1. Bring the vehicle to a complete stop with the foot brake. 2. Lift and rotate the work brake lever clockwise (toward the driver). 3. Lower the lever into the locked (applied) position. WARNING Loss of vehicle control could occur if the vehicle is in motion when the work brake is applied (due to wheel lockup on slippery surfaces). In addition, using the work brake before the vehicle is stopped could throw the operator from the normal driving position.