Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY SWING MOTOR 12SWING MOTOR SWING MOTOR REMOVAL WARNING! Release the remaining pressure in the hydraulic circuit. For details, see TEST- ING AND ADJUSTING. WARNING! Loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. # Fit blind plugs in the disconnected hoses and tubes. 1. Disconnect suction hose (1). 2. Disconnect swing hoses (2). 3. Disconnect drain hoses (3) and (4). 4. Disconnect swing holding brake hose (5). 5. Remove mounting bolts, and lift off swing motor (6). Swing motor................................................................. 110 kg INSTALLATION G Carry out installation in the reverse order of removal.

# Refill with oil [hydraulic tank] through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. # Bleed the air from the swing motor. For details, see TESTING AND ADJUSTING. 30-2 PC300LL-6